'04 196 Limited

[2004196]

Putting my 196 on the market, original owner, fresh water only. 440+/- hrs as of this date. Boat has: PCM 330hp Excalibur, limited options such as keyless, heater, shower, pull out cleats, flip up bolster on drivers seat, PP upgraded to 6.5NG, fiberglass swim platform, black bimini, two covers – one loose mooring and one fitted. Other things added include "Nautique" carpet addition, 5 blue underwater lights by Ocean LED (2 - A3's & 3 - A6's) wired to existing keypad through existing factory wire harnesses, interior LED's and custom front navigation LED's all wired to keypad, LED docking lights, powered boot blaster for boot lube, Cipa extreme mirror, twin axle trailer w/ upgraded 17" tires and Foose Wheels, LED lights, rear prop guard rollers and removable tongue. Trailer has been a garage queen rarely used and often waxed. Boat has had anal care and is in near perfect condition in and out, 9.5+ out of 10. All engine maintenance has been performed to above and before any recommended intervals (all documented from day 1) and you can eat off the engine, if you wanted to for some reason. Runs perfect. Has had Mobil 1 most it's life, boat lives on completely covered lift in summers and heated garage Nov - March. I have never had an issue with this boat/trailer and it shows in its condition. I am asking $26.5K and willing to work some on delivery locations around WA, boat is in Lakewood. Can send additional pictures to those interested.

[jmo]

Beautiful boat and trailer - love the navigation lights, were those installed from the factory? if not what did that cost you to install, I'd love to do the same forward and aft docking lights.

[2004196]

Thanks jmo, I installed the navi lights, they are 7" LED's from superbritghtleds.com http://www.superbrightleds.com/cgi-b...bes.htm%23lt-x) (and I think they were around $13 ea. Siliconed in place and a little double stick carpet type tape to hold in place until the silicone set up. Wired directly into the wires for the front navi light so work on same keypad switch as before. Easy to do as wires run right though the plastic intake behind those vents.

[todda]

PM sent

[jmo]

Thanks jmo, I installed the navi lights, they are 7" LED's from superbritghtleds.com http://www.superbrightleds.com/cgi-b...bes.htm%23lt-x) (and I think they were around $13 ea. Siliconed in place and a little double stick carpet type tape to hold in place until the silicone set up. Wired directly into the wires for the front navi light so work on same keypad switch as before. Easy to do as wires run right though the plastic intake behind those vents.

how about the docking lights, did you have to drill through the hull to attach & wire?

[2004196]

Docking lights take a 3/16" or so hole for the wire and two screws mount the lights. Predrill those holes (1/8") to prevent cracking of the fiberglass but these do not take the 2" or so hole for regular halogen type docking lights. I used 3M 5200 on the wire and screw holes just as a precaution, everything is above the waterline. I think the docking lights are Attwoods, don't remember exactly where I got them but look on the attwood site.

[2004196]

Sold