Ramlin swing away tounge conversion kit $150 obo

[Miljack]

I have a Ramlin swing away tounge conversion kit to fit their older trailers. The trailer I was going to install it on was a single axle for a Pro Air (21' boat) and had the "swing up" tounge. I had to get that trailer repaired at Ramlin, and they were going to install this kit when they had it, but ran out of time. Kit has all the pieces needed to convert a single tube/coupler type of trailer. Asking $150.00 obo.
Boat/trailer sold, so this needs to go!

[2Tuff]

Sending a PM now

[Miljack]

2 PM's replied to. thanks for the interest guys.

[Miljack]

A couple of other pics; kit will weigh approx. 30# shipped.

[Miljack]

Sold! Thanks DoubleD!

[Double D]

Sold! Thanks DoubleD!

Arrived and intact, ready for install. I will send pictures after that is done. Thanks Miljack!!




Sent from Never Neverland using my iPhone 4 on Tapatalk

[Miljack]

Just looking at your setup, I think you could get the pivot back to where the rear bolt for the coupler goes through the existing tounge. You could shorten the top plate a bit to make room for the winch stand/bow rest, and the bottom plate could go on as supplied.

Have fun with the welding, you're gonna want a BIG welder!

thanks again and enjoy!

[Double D]

Miljack, all done sir. Just got it mounted today and I like it! Fits and works good!! Here is one before and four after pictures for your enjoyment...

..

[Miljack]

Cool, glad to see it's gone to a good home! Enjoy, looks great!