2000 SAN - Austin Tx

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • MaineDR
    • May 2015
    • 131

    • Austin, TX

    • 2000 SAN

    2000 SAN - Austin Tx

    Thinking about selling my boat. I just don't use it enough at the moment. I have put a good deal of work into it over the last year. I will probably edit this later but general specs on it are below:

    - GT-40 (hours unknown due to gauge issue, but likely around 500-600 based upon information I got from dealer) had it compression tested when I bought it and it was all within spec. It has run great to date.
    -New Faria Gauges (Tach and Speedo)
    -Just did general maintenance (oil, tranny oil, impeller)
    -Stereo: New interior speakers - Polk DB651s - rewired interior speakers from the head unit to the amp
    Boss 400w amp (cheaper amp, but works for now)
    Marine Bazooka tube sub
    2 DB651s on tower
    -Flight control clips
    -Snap on sunbrella cover with zip off separate bow snap on cover
    -Bimini Top
    -Ballast: 2 Jabscos filling fly high 750s
    2 800 tsunamis for 600 in the ski locker-
    -Perfect Pass (older version but still works well)
    -New key pads (installed by previous owner. These are known to go out, so no need to worry about these. This is close to $1000 alone to replace both keypads)
    -New struts for various compartments throughout (these go bad over time)
    -Wet sanded and polished gelcoat with some new decals
    -Refinished and re-oiled teak swimdeck
    -New PVC engine dividers
    -Vinyl was redone within the last few years (few minor blems I repaired)
    -2009 boatmate twin axle trailer with swing away tongue

    Asking $24k but open to negotiating
    Attached Files
    Last edited by MaineDR; 03-13-2017, 09:54 AM.
  • MaineDR
    • May 2015
    • 131

    • Austin, TX

    • 2000 SAN

    #2
    A few more recent ones of the interior. I will get a few more good ones once I can get it out of the garage. It has been raining here non-stop. You can see some of the minor defects in the vinyl. There are two 'poc' marks on the port seat back I repaired with a little vinyl adhesive. The seam on the center back seat cushion is showing a little wear as well.
    Attached Files

    Comment

    • MaineDR
      • May 2015
      • 131

      • Austin, TX

      • 2000 SAN

      #3
      Bump


      Sent from my iPhone using Tapatalk

      Comment

      • MaineDR
        • May 2015
        • 131

        • Austin, TX

        • 2000 SAN

        #4
        Still for sale.
        Last edited by MaineDR; 06-17-2016, 09:26 AM.

        Comment

        • brit_hunsicker
          Senior Member of PLANETNAUTIQUE
          • Oct 2014
          • 482

          • Overbrook, KS

          • 2001 Super Air Nautique

          #5
          Can you PM your number? I know a guy who is interested but he does not have an account. Thanks


          Sent from my iPhone using Tapatalk

          Comment

          • MaineDR
            • May 2015
            • 131

            • Austin, TX

            • 2000 SAN

            #6
            Back up for sale this year. I ripped out the carpet toward the end of last season and put in Seadek. This is the only pic I have at the moment of it. She hasn't been out of garage yet this year, so I will be looking to get her up and running here in the next week or so.
            Attached Files

            Comment

            • MaineDR
              • May 2015
              • 131

              • Austin, TX

              • 2000 SAN

              #7
              Bueller...Bueller... very willing to negotiate on price

              Comment

              • macpres
                • Feb 2014
                • 94

                • ST Paul

                • Past: 2002 Nautique Super Air 2018 G23 2019 G23 2006 Wakesetter 247 2020 G23 2021 G23 2022 G23 2023 G23 2024 S23 2024 G23 2025 G23 2024 GS24 2005 Supra Launch 21V Current: 2025 G23, 2023 Malibu Response and 2005 SANTE

                #8
                extremely interested as to how you went about the carpet removal/sea deck installation. Can you tell us how you did that? looks great and i hate my carpet

                Comment

                • MaineDR
                  • May 2015
                  • 131

                  • Austin, TX

                  • 2000 SAN

                  #9
                  Used something called Monstaliner to seal the fiberglass under the carpet and then ordered some blank sheets from SeaDek. Layout a template and cut/route the sheets. Sounds simple, but it was actually quite a bit of work. If I were to do it again I wouldn't go up under the bow. I would just leave the carpet there. Scarbs did this on his boat originally and has some good writeups on it.

                  Comment

                  • MaineDR
                    • May 2015
                    • 131

                    • Austin, TX

                    • 2000 SAN

                    #10
                    Bump

                    Comment

                    • MaineDR
                      • May 2015
                      • 131

                      • Austin, TX

                      • 2000 SAN

                      #11
                      Price drop...now asking 22.5k

                      Comment

                      • ReconGaelach
                        • Feb 2017
                        • 4

                        • Greenwood, IN

                        • Looking!!

                        #12
                        Great looking boat. Hope this is still available in the fall when I'll be ready to buy. One of my favorite colors!

                        Comment

                        • MaineDR
                          • May 2015
                          • 131

                          • Austin, TX

                          • 2000 SAN

                          #13
                          Why wait?!

                          Comment

                          • ReconGaelach
                            • Feb 2017
                            • 4

                            • Greenwood, IN

                            • Looking!!

                            #14
                            Got to pay a couple things off. Unless I see the deal of the century I have to be patient.

                            Comment

                            • Nicholas Allen
                              • Apr 2017
                              • 9

                              • Wisconsin


                              #15
                              Shoot me a text with some pictures of the hull if you could. 7153602012 thanks. Debating between a San and an axis a22


                              Sent from my iPhone using PLT Nautique

                              Comment

                              Working...
                              X