SOLD - Pebble watches with the Surf Select app Installed

[charlesml3]

Gang,

I have six Pebble watches for sale. All of them include the charging cord and come preinstalled with the Surf Select app.

These will work on any Nautique MY 2017-2019 that has the Surf Select module installed in the boat. It will work on a MY 2016 ONLY if the boat was fitted with Surf Select 2.0 module. These WILL NOT WORK with any Surf Select Module version 1.0 or 1.2. I cannot make them work with those modules.

Notice that the watches are grouped four on the right, two on the left. The four on the right are perfectly good. The two on the right have the "screen tear" issue. This is caused by a ribbon connector inside the watch getting loose from time to time and causing a "tear" in the display. The fix is to flip it over, put your thumb in the lower middle of the cover and press down hard. This will reseat the connector but it'll eventually loosen again. It isn't a fatal problem. Just somewhat annoying.

Prices on eBay are all over the place for these so I'm going to start here:

The four on the right are $50 each PLUS shipping.
The two on the left are $35 each PLUS shipping.

[charlesml3]

The two black ones on the right are sold (pending)

[wesp]

do you still have any of the pebbel watches?

[Proedge]

any left?

[charlesml3]

The four on the right are all sold. I still have two of the black ones left with the "screen tear" issue. Occasionally, you'll have to squeeze the case from the back to reseat the cable.

-Charles

[Hacker123456]

Do you have any left, if so, I would like to purchase the remaining watchs.

[charlesml3]

Yea. I have the two on the left. These both have the "screen tear" issue that has to be sorted from time to time.

-Charles

[Hacker123456]

Great!!! I’ll take them both… I just bought a 2016 g23. How much do you want for them?

[charlesml3]

Quote removed by Admin for not following the Guidelines for Quoting Previous Posts in a Thread.

Sent you a DM.

[Hacker123456]

Please email me at johnwvineyard@yahoo.com. I don’t see the dms on this site

[charlesml3]

These will likely not work on a 2016. It's possible, but only likely if the dealer or previous owner updated the Surf Select module. It must be version 2.0. There's a sticker on the wire going into the surf select module. It'll be in the starboard compartment, way in back and up high on a bulkhead panel. You can also see it in version number in the LINC.

Let's get that sorted before I send these to you.

-Charles

[NautiqueJeff]

Please email me at johnwvineyard@yahoo.com. I don’t see the dms on this site

You should be able to see them under Messages at the very top of the screen.