Tower mirror bracket

[DynaMike]

Here is another drawing, we have something tricky planned for the clamping end for adjusting the bracket angle. I promise not to use any registered trademarks.

[DynaMike]

Here is a rough draft, the arm is waterjet cut only with a quick polish. There will be chamfers on all edges and all id and od sides will be milled clean. Not shown is the second part of the clamp that will allow you to rotate the entire arm over 90 degress
back towards the driver. The 3/4 rod is also not shown. The overall length is 17 inches and the widest part is the outside of the clamp at 4".

[Andrew]

looks like a good start!