1996 Super Sport Nautique Ballast Install

[delmage171]

This is the first time installing on a boat. My previous boat (1989 Ski Nautique 2001) I used 3 - 400lb vdrive sacs pumped in with a tsunami

This boat I looked over various other threads to get ideas and work off of them!


Everything was from Wakemakers, Jason & Spencer are awesome to deal with

3 - 400lb vdrive sacs
1 - 1000lb triangle bow sac
4 - Jabsco Ballast Puppies
4 - 3/4" bronze thru hulls
4 - 3/4 ball valves
4 - 3/4" to 1" hose connectors
All fill & MT lines with 1" hose
All Vents 3/4" hose
7 - 3/4" full stainless above water thru hulls
4 place switch holder
Inline fuse holders
3M 5200 - below water
Marine Wire - 12 gauage - 60ft

Some custom Labelling

[delmage171]

rear vents & bilges


switches


New Decals


front vents

[MI-Nick]

looks great!! i'm planning something similar on my '99 SAN this spring. good you give me the details on how/where you mounted the pumps??
also, where did you get the switch holder, fuse holder, and wire??
thanks a lot.

[delmage171]

Mi-Nick

I mounted the pumps right infront of the engine behind the rear seat. I mounted 1/4" aluminum plate between the 2 support posts. 2 of them are stepped out with 1x1" aluminum square tubing. All stainless hardware.

The switch holder, fuse holders and wire were all from wakemakers. They will help you out for sure

[MI-Nick]

thanks!!