New to SV211

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • trabecula
    • Sep 2013
    • 18

    • colorado

    • SV 211

    #1

    New to SV211

    I have had a prior 206 and now purchased a 2004 SV211. This boat is very different than the old one and I need some help. First, I cannot find the location of the hull plug. Is it buried somewhere? Also, I have the two battery setup. There is no power to the keypad in any position of the cutoff switch. I have checked for battery charge and even if somewhat low (12.2 volts), the keypad switch will not light and the horn will not work. Is there some main circuit breaker or fuse to check? Does the blige pump switch position have some bearing on the power to the keypad?

    Thnks
  • Woody_tobius_jr
    • Dec 2012
    • 248

    • Alberta, Canada

    • 2004 SV211 Air Nautique TE

    #2
    There is a door just below the back seat ( if you have the TE) its about 8" x 5" If your looking straight down the plug is there.
    Did you check the 3 way toggle on the panel All on All off Bilge only. If your sitting in the drivers seat, it will be by your right calf/knee on the side. Hope that helps.

    Comment

    • HS
      1,000 Post Club Member
      • Oct 2007
      • 1333

      • Sammamish, WA

      • 2010 SANTE 210 (Sold)

      #3
      You started at the "cut off" switch -- by that do you mean the battery selector knob in the port locker? If so, good, then as Woody says, check the toggle switch under the helm. There is a main breaker panel in the locker and circuit panel under the helm.
      2010 Super Air Nautique 210 Team Edition

      Comment

      • trabecula
        • Sep 2013
        • 18

        • colorado

        • SV 211

        #4
        Thanks to you two. This will be very helpful

        Don

        Comment

        • Mahoo
          • Oct 2008
          • 27

          • Georgetown Texas

          • 2005 SV211 team

          #5
          If you have the keypad, then once you have the batteries on, and under helm switch on, then you need to enter the keypad code and press start. That should power up the boat.

          Comment

          Working...
          X