Ever cut a 210 in half?

[Nautiques_NZ]

We had this old 210 sitting around in the yard and figured we might put it to use....... The back half will be a counter in our proshop. The pointy end....... Not so sure what to do with that right now.

[ers906]

Manager or officer's desk. Cut out the floor and you have U shaped wrap-around desk. Put a nice hardwood top on it etc.

[hyparks]

Shame to see this happen to an amazing boat!

Sent from my HTC One using Tapatalk 2

[ES]

Ha ha, looks good. What did you use to cut it? Looks a very clean job!

[Nautiques_NZ]

Ha ha, looks good. What did you use to cut it? Looks a very clean job!

Sabre Saw! like a hot knife through butter.

[Chexi]

I kind of want to fly to New Zealand just to punch you in the face for this. I kid.

[Jahrdr]

I hope you taped the area off and had the saw in reverse until you got through the gel. If it were me I'd also take the sharp edge off everything to avoid spider cracking.

[gride]

how about get creative and make the "pointy part" into a sign for the business?

[Nautiques_NZ]

how about get creative and make the "pointy part" into a sign for the business?

I'm thinking that will be the end result, might have to cut it back to the screen....... then i will have the side as a sweet looking bar leaner!
Just so ya know, it was a test hull from the factory and we have had it sitting around for about 6 years and was sick of seeing it out in the yard growing weeds..... I figure this will be a better use for it. It was a long long way from ever being a usable boat.

[Paxdad]

I kind of want to fly to New Zealand just to punch you in the face for this. I kid.

If you make it to NZ please bring back the tower for me.

[Zach@n3]

We parted an 87 out and are planning on making the transom a counter or bar. The bow section will get ripped down the center then joined at the back half so the nose points both directions for another longer bar. should end up being pretty neat.