Tweet
I just wanted to put the instructions for using the older versions of Correct Craft Cruise out there in case anyone needs them. This is for the original Correct Craft Cruise system, with the small 2" controller that mounts in the dash, like the picture below.
Optional Correct Craft Cruise Operating Instructions:
Turn system ON (light blinks slowly, indicating system is armed) Drive to desired speed, press ENGAGE and the system takes control of the throttle (Light stays on steady) Pull back on the throttle and the system disengages. (Light blinks rapidly, indicating RESUME function is ready) Accelerate again and the system resumes control automatically at the last speed used. RESUME key feature will recall the last speed used even if the system was shut off, completely powered down or the DISENGAGE function was used. To go back to the previous speed, press RESUME and drive to the desired speed. Press both keys and the system will DISENGAGE, but remains armed. (Light blinks slowly) This feature may be used when the operator wishes to go to manual driving. To return to the last speed used, press the RESUME key and drive to the desired speed. If the speed is to be changed, drive to that speed and press engage. INCREASE / DECREASE key can be pressed when the system is engaged to change speed in 25 RPM increments to fine tune the speed. User tips: Always return to neutral and let the engine idle for two or three seconds before turning the engine off Regularly check the black servo knob on the control unit to make sure it is turned snugly in a clockwise direction. To do this, turn the engine off and lift the top half of the engine box. Please note, the servo knob cannot be moved if the engine is on. Regularly check the set screw on the side of the black knob for tightness. The boat speed will decrease in sharp turns. If you are towing skiers, you may wish to manually increase the throttle or use the DISENGAGE feature to maintain speed in sharp turns. When towing wakeboarders, accelerate slightly past desired speed prior to engaging the speed control.
Optional Correct Craft Cruise Operating Instructions:
Turn system ON (light blinks slowly, indicating system is armed) Drive to desired speed, press ENGAGE and the system takes control of the throttle (Light stays on steady) Pull back on the throttle and the system disengages. (Light blinks rapidly, indicating RESUME function is ready) Accelerate again and the system resumes control automatically at the last speed used. RESUME key feature will recall the last speed used even if the system was shut off, completely powered down or the DISENGAGE function was used. To go back to the previous speed, press RESUME and drive to the desired speed. Press both keys and the system will DISENGAGE, but remains armed. (Light blinks slowly) This feature may be used when the operator wishes to go to manual driving. To return to the last speed used, press the RESUME key and drive to the desired speed. If the speed is to be changed, drive to that speed and press engage. INCREASE / DECREASE key can be pressed when the system is engaged to change speed in 25 RPM increments to fine tune the speed. User tips: Always return to neutral and let the engine idle for two or three seconds before turning the engine off Regularly check the black servo knob on the control unit to make sure it is turned snugly in a clockwise direction. To do this, turn the engine off and lift the top half of the engine box. Please note, the servo knob cannot be moved if the engine is on. Regularly check the set screw on the side of the black knob for tightness. The boat speed will decrease in sharp turns. If you are towing skiers, you may wish to manually increase the throttle or use the DISENGAGE feature to maintain speed in sharp turns. When towing wakeboarders, accelerate slightly past desired speed prior to engaging the speed control.
Comment