OK, which one of you did this?

[FMSKI]

That tower looks amazing for sure. $3500 USD if I can get it shipped to BC here. The Reborn is the same idea, minus the kink and mechanisms/hardware. Nautiques are stout hulls. Pull force is up to say 1000lbs at the pin so must support the torque of, or lift around that front attachment, plates distribute the load. .

I'll have to do up a budget. My plan for ballast, sea dek and all the goodies is $10K .

[FMSKI]

Question for Jeff on tower installation - Do you remove the interior panels and padding or... there is an access hole on the SV211 - it's tight but big enough for the hand on one side. There is the heater cavity on the other. That might be fine for attaching the tower bolts.

My Aviator (moomba spec in white much like photos above) is arriving tomorrow. thks

[NautiqueJeff]

It is easier if you remove the panels. It might be able to be done without doing it though. On the 226 that we did, the panels were already off.

[FMSKI]

thanks for the info.

[NautiqueJeff]

Can you believe it? There's actually another Nautique owner who thought this tower was a good idea........