Engine Cover Ram Wiring

[rossl2]

Hi All,

Does anybody know the wiring setup for a hydrolic lift ram that lifts the engine cover on a 1996 super sport Vdrive nautique, I managed to pull the 6 wires of the back of the 3 way switch and dont know which way they go back on !!!

I have a three way up/middle/down position switch which has 6 terminals on the back.
I have a 4 different wires.
Pink wire - Has 2 female spade connectors on end - Runs to ignition switch.
Black wire - Has 2 female spade connectors on end.
orange wire - single female spade connector on end.
orange with black stripe - single female spade connector on end.

I have tried lots of different variations: I can get it to go up only , down only or up and down for a few seconds before the pink wire starts to smoke!!

Any ideas??

Cheers
Rossl

[bchesley]

RE: Engine Cover Ram Wiring

I will try and get by the lake house this week and check for you. Mine should be the same.