Tweet
so i have the 330 hp in my 05 210. i havnt had any problems with it and july 4th i go out and it idles at 1300rpm's and revs to 2000 in neutral, but operates normally with perfect pass at speed. engine temp is about 172/(closed loop) and volts are fine and oil pres. is about 50psi at speed. any suggestions? and it kind of kicks into gear
-
-
RE: idle problem
any thoughts? i'm thinking i might just need a new throttle cable.. -
RE: idle problem
A throttle cable would be my last guess.
Your description of your problem is not very good. That is why 40+ views and no reply.
Can you elaborate more on the problems and tell us what else you've done to diagnose? IN ADDITION, describe "...but operates normally with perfect pass at speed."
AirToolComment
-
RE: idle problem
so basically i bought it about 2 months ago from a dealer used. i put 30 hours on it with zero issues and took it in to have closed loop cooling installed and the flush b/c i moved to bama. the first time i used it since they put the system in and did a service (oil, impellar...) was july 4. for the first 10 minutes or so it was fine, but then it started to idle at 1300rpm's which is much faster than the usual 900 or so, and when put into neutral the engine rev's up to 2000rpm's. when i put it back in gear it kicks and idles quickly again at about 1300rpm. my engine temp seemed fine at 172ish and my oil pressure was at about 50plus, volts fine, throttle feels normal, and it holds a steady speed and runs normal rpm's while pulling a wakeboarder using perfect pass. it is the excalibur 330 engine with closed loop cooling. any help would be much appreciatedComment
Comment