shower/heater pump location 99 v-drive

[nautiquedave]

First would like to thank everyone for there response on my other posts they are very helpful.My question now is where is the correct location for the shower/heater pump mine was zip tied to the exhaust right next to the alternator.I figured that was not right since the exhaust was collapsing from the zip ties.Any suggestions will help.Final question what is the correct impeller for a 99 nautique with a gt40 thanks.

[DavidF]

RE: shower/heater pump location 99 v-drive

The heater does not use a seperator pump. The engine circulation pump takes care of it. The shower pump on my '99 NSS is bolted to the engine cradle on the starboard side about mid point. Not sure about impellar, I just pick them up at the dealer every few years. Sherwood standard stuff.

[WakeSlayer]

RE: shower/heater pump location 99 v-drive

My pump is located in the back port side against the transom. I would double check your exhaust hose if it is collapsing from a zip tie. I do not think it should do that.
FWIW, I am removing my shower this Spring. I never use it.

[2Tuff]

Re: RE: shower/heater pump location 99 v-drive

My pump is located in the back port side against the transom. I would double check your exhaust hose if it is collapsing from a zip tie. I do not think it should do that.
FWIW, I am removing my shower this Spring. I never use it.

What are you going to do with it? I am thinking about adding it to my SAN, I assume they would be the same? My dash has the controls for it, does that mean the boat is pre-wired for it, and all I have to do is hook it up?

[WakeSlayer]

RE: Re: RE: shower/heater pump location 99 v-drive

It is pre-sold, sorry.
Depending on the year, I think there is a connector tied up back by your motor. Cannot remember the color of wires.

[jward]

RE: Re: RE: shower/heater pump location 99 v-drive

For the shower pump, if they do them all the same, look behind the driverside rear motor mount. The last two I installed was there, zip tied to the bilge wires. Off the top of my head I believe it is a black wire for the ground and an orange wire witha black stripe. there will be a plug, on one side the wires go to the dash and on the other side it will be looped back to the plug.