leaky port ballast tank on 211 - any ideas?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • clubmyke
    Senior Member of PLANETNAUTIQUE
    • Sep 2004
    • 414

    • so cal


    leaky port ballast tank on 211 - any ideas?

    my port side ballast tank is leaking on my 05 211- i can hear dripping when it is filled up (the carpet is dry underneath).

    any ideas before i take it apart ?

    thanks,

    mike
  • WakeSlayer
    1,000 Post Club Member
    • Sep 2005
    • 2069

    • Silver Creek, MN

    • 1968 Mustang

    #2
    RE: leaky port ballast tank on 211 - any ideas?

    My friend has an 05 that is in the middle of a very slow system upgrade. He always had a bunch of excess water in his. Turned out that the neck on the bilge pump on the bottom side had cracked 3/4 of the way through. There would be no way to fix this without completely replacing the pump. We saw it after the tanks were pulled so not sure if there is a way to do it without removing the tank. Hopefully this helps you.
    the WakeSlayer
    1999 Super Air - Python Powered <-- For Sale
    1968 Correct Craft Mustang

    Comment

    • nms1991
      Senior Member of PLANETNAUTIQUE
      • Apr 2004
      • 477

      • Unknown


      #3
      RE: leaky port ballast tank on 211 - any ideas?

      I also would check the empty pump on the tank as the pump sometimes has a problem cracking at the seams.

      Comment

      • WakeSlayer
        1,000 Post Club Member
        • Sep 2005
        • 2069

        • Silver Creek, MN

        • 1968 Mustang

        #4
        RE: leaky port ballast tank on 211 - any ideas?

        by bilge pump, I meant the drain pump on the bottom of the tank. They are just bilge pumps.
        the WakeSlayer
        1999 Super Air - Python Powered <-- For Sale
        1968 Correct Craft Mustang

        Comment

        • Mikeski
          1,000 Post Club Member
          • Jul 2003
          • 2908

          • San Francisco, CA

          • Current 2005 SV 211, due for upgrade! GS22 or GS24 perhaps? Previous

          #5
          RE: leaky port ballast tank on 211 - any ideas?

          hmmm, I think you run pop bags on top of the tanks right? You might have a little crack in the tank somewhere near a corner? Pull it out, I have had mine out, it's not awful bad, just a little pita. Use a heat guy to remove the hoses. The starboard tank is easier to get out but it's not that much harder.

          Comment

          • clubmyke
            Senior Member of PLANETNAUTIQUE
            • Sep 2004
            • 414

            • so cal


            #6
            Thanks for the help everyone- turned out to be a cracked pump fitting.

            Comment

            • Mikeski
              1,000 Post Club Member
              • Jul 2003
              • 2908

              • San Francisco, CA

              • Current 2005 SV 211, due for upgrade! GS22 or GS24 perhaps? Previous

              #7
              make that HEAT GUN to help remove hoses

              Comment

              Working...
              X