Tweet
I overheated my engine on the first trip out this summer. After I got it going again with a new impeller I noticed that I now have a small amount of water and exhaust gas escaping from where the fiberglass riser goes into the rubber hose that connects the riser with the manifold. It is on the starboard manifold only. When it got hot, I must have melted the fiberglass or rubber so that there is no longer a good seal. I tried tightening the clamps on the rubber but it did not seal it back up. What is the best fix for this and does it hurt to run it like this in the meantime?
- Welcome to PLANETNAUTIQUE! We're glad you're here. In order to participate in our discussions, you must register for a free account. With over 25,000 registered members already, we would love to have you as a member too! Click here to access our Registration Page. Registration is quick and easy, and we keep any information you give us completely confidential. Once registered, you may sign in using the drop-down Login or Sign Up window at the upper right corner of the site.
Comment