2008 SV211 trouble code states "MAN ATR sensor"

[jre]

Not too sure what this sensor is? ANY help would be greatly appreciated. Engine has not yet entered "limp" mode.

[bkearney]

RE: 2008 SV211 trouble code states "MAN ATR sensor&quot

Same here. It's in and out - sensor more likely to blink (and beep) when engine is cool. Is it ok to run until I can get it to the dealer?? (2008 Super Air 230 w/6.0 PCM)

[Laptom]

Hey guys,

Somebody knows the answer to this question? I now also have this error code? Engine is running fine, but sometimes this error pops up..

Thanks,
Tom

[bzurborg]

Man atr sensor

Has this been resolved by anyone - man atr sensor see dealer - I got this message also at low speed --everything appears to be normal??

[robertsmcfarland]

sorry, reading your messages but have no clue , always like to read explanation and remedies for future reference.

[Beachrat]

I have a 2008 Sante 210 & had a problem with a sensor my first time out 3 years ago but I can't recall which warning message showed up. The boat ran great & all guage readings showed normal but the warning beep was very annoying...I recall my dealer replacing the gateway under warranty.

In the owners manual it shows a MAN AIR SENSOR SEE DEALER as being a (maniflod air temperature sensor malfunction).

[DanielC]

It is the air temperature sensor in the intake manifold. this is one of the many sensors the computer uses to calculate the amount of fuel to run into the engine. When you first start the engine, the computer compares the reading from this sensor to other temperature sensors, and if it finds a discrepancy, it sets a code.

look for the sensor. I would tell you where to look, but I only have a GT-40 engine. Make sure the wire is hooked up to it. Beyond that, you probably need to go to a dealer.