What are the factory prop specs

[maxxwell]

I have a 2008 SV-211 TE with PCM EX343

What are the specs for the factory prop? I work overseas and cannot get to my boat.

Any help is appreciated

[maxxwell]

anyone?

[Mikeski]

I have found that Nautique is not completely consistent with props on our 211's. I would guess that your boat should have an Acme 645, that is 13.25 x 16" LH with 0.105 cup. This is what the team 211's I have seen have had in the past.

[maxxwell]

Mikeski, Thanks for your help... after researching, I came up with the same. I contacted a local dealership here and they were not sure but also stated the 645. I asked about 1235, and the guy laughed and said it was way too much for the boat.

I do surf quite a bit and will be adding another 1000lbs, wakeboard and skate, so I dont know what to get now.

Any opinions or suggestions?

[HS]

Acme

Call ACME props, they know Nautiques and make the 645, among others...

[maxxwell]

unfortunately Acme Props was did not know what comes on it from factory, although they did suggest 1234(5), also didnt know the rotation. But one of the local dealerships contradicted the recommendation of the 1234(5). I have the model number off the engine and the manual decyphers the numbers, so I do know that it is LH and above posts agreed the factory prop is probably 645. Recieved an email from David at White Lake Marine which again agreed the 645 to be the factory.....so, question is will the 1235 be the prop to go with?