Problem with rudder. Pro Air -99

[lampan]

Hi guys!
Iīve got some problem with the steering on my Pro Air -99!
I had an issue with my rudder being able to rotate too far in one direction, enough to hit the prop almost. Itīs like a "stop" or something is broken. But how do the "stop" work? It is in the steering-wheel, cable or in the rudder?
When I turn right it is a very logical stop, the cable cant go any feder but when I turn left itīs go out and out and out.. So far out that I canīt turn right , itīs get locked so I have to go back and put the "arm thatīs pushing the rudder" back in the right position.
If I get the rudder free from the cable I can turn it 270grades or something, itīs that right?



I hope you understand my problem I you can help me!
Mvh Philip

[WakeSlayer]

Philip,

I saw this exact post on CCF. I think you need a new correct cable. If you are unable to adjust it the other way from where you already adjusted it, I suspect you have the wrong cable installed. how long have you had the boat? If the original cable went bad, and it was replaced with a generic cable, that is likely the problem. CC uses/used proprietary cables and you have to get the replacement from them. They have different distance throws on them and will cause this problem.

Good luck.

[GC]

The throw of the CC rack and pinion cables is not any different than a generic Teleflex cable. The length of the OEM cable is 19.5 ft but a 20 ft cable works fine.

[lampan]

It's my first summer with the boat but the steering has been working all summer with no problems. But last time I was out I felt something in the wheel when I did a turn and after that I can turn to much to the left. What is it that it's broken with the cable?