Tweet
I just thought I would post this as I couldn’t find this information.
I spoke to the engineering department at Nautique for bunkspacing on a new HydroHoist I’m having installed. I was told to measure the spacing of the stringers that support the engines motor mounts and that would be the correct spacing in order to give maximum hull support. It would also be ok to taper the measurement by a couple of inches on each side in-ward to better support the bow of the boat.
I spoke to the engineering department at Nautique for bunkspacing on a new HydroHoist I’m having installed. I was told to measure the spacing of the stringers that support the engines motor mounts and that would be the correct spacing in order to give maximum hull support. It would also be ok to taper the measurement by a couple of inches on each side in-ward to better support the bow of the boat.
Comment