2007 210 no power to keypad..

[jarvis78]

Ok so I can switch the toggle to the down positon and get the bildge to kick on, but when I flip it up to the ALL ON postion there is no power. I removed the panel with the toggle switch and found what looks to be as if two wires have broken off....is this my problem?

[AirTool]

yep - you are not the first. I'm surprised to see 6 lugs and the wires soldered. Mine was three lugs and ring terminals with screws.

[jarvis78]

yep - you are not the first. I'm surprised to see 6 lugs and the wires soldered. Mine was three lugs and ring terminals with screws.

How do I fix this?? I can't locate the wires inside.

[AirTool]

How do I fix this?? I can't locate the wires inside.

I can't tell by the pic....to small of resolution. But are you saying the top left lug had a wire and it broke off?

I get it that you can't find it.

[Bucks89]

How ironic! Just encountered the exact same issue as your describe on a 2007 220. Bildge light comes on in down position but nothing when I toggle to all on. My switch looks exactly like the picture you posted. Any luck figuring out what the problem was?

[Agent banks]

I'm having similar issues on my 01 San. Bilge light will come on. But nothing else will. And randomly they will all work. Someone told me it could be a bad solder joint. Any help is appriciated !

[AirTool]

I'm having similar issues on my 01 San. Bilge light will come on. But nothing else will. And randomly they will all work. Someone told me it could be a bad solder joint. Any help is appriciated !

The lug has broken loose inside the switch housing. Sometimes it will work....sometimes it won't.

You need a new switch.

[Agent banks]

A new switch. Where is that located and how hard is this to replace ? Thanks for your help

[AirTool]

A new switch. Where is that located and how hard is this to replace ? Thanks for your help

Its the toggle switch. The one you are selecting "bilge" with.

Unless I'm all wet.

[Agent banks]

The switches are fine I used the 10 amp from my heater and prob still exist ? I think there may be a cold sauder joint in the starboard panel! Remember all the buttons work or don't work at periodic times. And I checked all switches. I'm baffled. It looks like there is no way to take apart the panel. Once again any info Is a help

[AirTool]

probably a relay. I don't know the wiring on your year model.

[Agent banks]

you dont think it could actually be the key pad? a relay makes sense. the only place they could be is in side the wiring harness. both key pads use the same harness so i hooked my start pad up to the starboard harness and every thing worked so i know it from the plug on the panel side up which gives me very little wire to look through ha... do you think i can find a used key pad or do i need to buy a new one?

[AirTool]

you dont think it could actually be the key pad? a relay makes sense. the only place they could be is in side the wiring harness. both key pads use the same harness so i hooked my start pad up to the starboard harness and every thing worked so i know it from the plug on the panel side up which gives me very little wire to look through ha... do you think i can find a used key pad or do i need to buy a new one?

You should start a new thread and maybe somebody with your generation system will be reading.

[Panda cub]

How ironic! Just encountered the exact same issue as your describe on a 2007 220. Bildge light comes on in down position but nothing when I toggle to all on. My switch looks exactly like the picture you posted. Any luck figuring out what the problem was?

Coincidence, not irony.