Plas Deck floor install Start to Finish

[Grant_West]

I got her out on the water for the first time last weekend and I love it.

[NautiqueJeff]

Looks great! One of these days I have got to see that boat in person!

[Grant_West]

Thanks Jeff: If you make it out to CA you wont be disappointed. Come visit us we would love to have ya.

[Grant_West]

This was Sunday night on our way back in from a Epic Day.

Here is a video of my Circus light LED display, this video was shot b4 a did the floor and a bunch of mods.
http://www.youtube.com/watch?v=IB0ZibJck2Y

[shag]

That is amazing! And the LED light show, I'm speechless...... Very nice!

[jasper]

Grant, good to see you back on PN. The work you do is simply astounding. I'm not into bling, but your LEDs are just plain awesome. Thanks for sharing your work and documenting on PN a lot of what you've done and how you did it.

[jasper]

Also, I meant to add that I've been waiting to see someone do the conversion from carpet to Plas Deck or similar, and I didn't think it could be done tastefully. You proved me wrong. Great job.

[Chexi]

Your talents are without equal. Someday, if I am really adventurous, I will try this on my 2000 SAN. It should be easier, considering the configuration. Thank you for yet another nice guide.

[Nauti-by-Nature]

Wow, very cool! Thanks for sharing.

[toddrswenson]

I'll send my 02 out to you. That looks awesome. If you don't mind me asking, do you know what the total cost of the project?

[Grant_West]

My floor was $3.000. Here is how it broke down. Originally I mapped the floor out to only cover the surfaces you could see and walk on . That would have set me back like $1500. But as I started getting into it I figured I would just do the whole floor and be done with it. Doing under the sub boxes and under the sets and the trunk almost doubled the SQ footage. Then the added cost of the margins, and that's how we got to 3k deliverd. That also included all the glue and tolls to install it. If any one needs help and or advice doing a project like this PlasDeck was a great company to work with. They helped out a lot threw the process.

Here is there contact info
www.PlasTEAK.com
www.PlasDECK.com
1-800-320-1841 ext. 112
1-330-668-2587 ext. 112
1-330-666-0844 (fax)
PO Box 4290, Akron, OH 44321 USA

The person I delt with is Jennifer LittleBear
International Sales Coordinator

[Laketexoma]

What controller did you use for the LED's? Will 1 drive the entire boat? It looks amazing!

[bscott]

Very cool ... and looks great. I like the LED show, too.

Now, what's the next project?

[Grant_West]

Hey thanks for all the kind words. As far as being talented I think the gentleman from Australia that did his own NSS system is been by far the best D I Y I have ever seen my little floor project look like a walk in the park.

As far as what's next? Come on is that a serious question!!! I think what's next is to enjoy my project! however I do have a few little cleanup things to do but nothing worth really mentioning

[Grant_West]

Oh and about my Led controller. Yes it's a single LED pixel controller it's quite different the way did acts. My controller can see and control each individual LED. It's rather simple design but very complex. I wouldn't recommend these lights To the average do-it-yourselfer. Pixel controller is located in the tower and then I had to run an amp to further push the signal through the boat. The pixel controller and the amp and the LED pixel strips and all designed to work together you simply couldn't use my controller on a standard RGB LED strip.