Tweet
How do I remove the driver's seat on a 05 SANTE? I would like to have the seat slide powder coated.
This seat has the split seat bottom that provides the high chair affect. On an older standard CC drivers seat there are four nuts that hold the seat base to the seat slide. In my pictures, the two front seat base nuts are seen. The two rear nuts are under the rear half of this seat.
As seen in the picture, there is a bracket that holds the rear half of this seat to the base.
Because of this bracket, I do not believe I can lift the rear half without removing front half first. There are four screws on each side of the front half that screw in from the bottom that hold the front half to the swing mechanium that provides the high chair affect. The access to these eight screw makes it dificult to remove these screws.
Has anyone done this? How is this done? There has got to be an easier way to remove this seat.
This seat has the split seat bottom that provides the high chair affect. On an older standard CC drivers seat there are four nuts that hold the seat base to the seat slide. In my pictures, the two front seat base nuts are seen. The two rear nuts are under the rear half of this seat.
As seen in the picture, there is a bracket that holds the rear half of this seat to the base.
Because of this bracket, I do not believe I can lift the rear half without removing front half first. There are four screws on each side of the front half that screw in from the bottom that hold the front half to the swing mechanium that provides the high chair affect. The access to these eight screw makes it dificult to remove these screws.
Has anyone done this? How is this done? There has got to be an easier way to remove this seat.
Comment