Tweet
2013 Nautique 200V TE won’t start
2013 200V TE won’t start
Turned off engine after driving to flat water and stopping to set up rope/pylon and boat wouldnt start again. Tried everything - confirmed in neutral, lanyard attached and set properly. No signal to starter, no click, no turn over. restarted lync system with master switch and nothing again, did it once more and hit the bilge switch and boat started...... kept it running, went skiing. at the end of the run boat cuts out again. This time just hit start and off we went. Back to the dock, went in for lunch and came out later for a cruise and nada, nothing - no click, no turnover. Power works for everything else but engine is on strike.
Any ideas?
Turned off engine after driving to flat water and stopping to set up rope/pylon and boat wouldnt start again. Tried everything - confirmed in neutral, lanyard attached and set properly. No signal to starter, no click, no turn over. restarted lync system with master switch and nothing again, did it once more and hit the bilge switch and boat started...... kept it running, went skiing. at the end of the run boat cuts out again. This time just hit start and off we went. Back to the dock, went in for lunch and came out later for a cruise and nada, nothing - no click, no turnover. Power works for everything else but engine is on strike.
Any ideas?
Comment