G23 Circuit Fault on NSS Port

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • st68
    • Feb 2014
    • 191

    • Roswell, Georgia


    G23 Circuit Fault on NSS Port

    I wanted to see if anyone has experienced this... I have a circuit fault on NSS Port... has the orange triangle next to it on the diagnostics page.... have tried to reset by hitting reset button, cycled battery off/on 3 times + start button, pressed circuit board buttons.... and nothing has worked... waiting to hear back from dealer but hoping it is simple so I wanted to put this out there. They think it might be electric actuator but checking on it... the only modification I did was add an LED light to the transom grills that light up when the switch surf button is touched but this takes so little power I can't imagine this is causing it but I guess it is possible.... anyone else experience anything like this? Thanks
  • ddipert
    • Nov 2013
    • 116

    • Mebane NC

    • 2010 SANTE 230

    #2
    It doesn't sound right that a LED would cause an issue. But I would undo what your have done to see if that clears up the issue. Are you sure you have good electrical connections on the work you did?

    Comment

    • st68
      • Feb 2014
      • 191

      • Roswell, Georgia


      #3
      Originally posted by ddipert View Post
      It doesn't sound right that a LED would cause an issue. But I would undo what your have done to see if that clears up the issue. Are you sure you have good electrical connections on the work you did?
      Checked it today and the one LED had one of the screws we used to fasten it go through the outer wire coating and was touching the wire... corrected it and works just fine again.

      Comment

      • ddipert
        • Nov 2013
        • 116

        • Mebane NC

        • 2010 SANTE 230

        #4
        Good to hear it was a simple fix.

        Comment

        • robertsmcfarland
          Senior Member of PLANETNAUTIQUE
          • Oct 2004
          • 544

          • Hyco

          • 2014 g23 550

          #5
          so the light come on to tell the surfer port or starboard???? sounds like a needed feature...
          2013 G23 super air
          2010 230 super air
          2009 220 super air
          2008 210 super air
          2005 210 super air
          2003 calabria pro air

          Comment

          • st68
            • Feb 2014
            • 191

            • Roswell, Georgia


            #6
            Originally posted by robertsmcfarland View Post
            so the light come on to tell the surfer port or starboard???? sounds like a needed feature...
            Yes if you surfing port side and want to transfer to starboard then there is a strip of 9 blue LEDS inside the port vent that flash to let you know the switch surf has been pressed, same on the other side. Sometimes there is fumbling of fingers when you signal the driver to switch so this insures you can know for sure... the 2015 Malibus will have a horn that will sound and the tower lights will flash 3 times to tell the rider then the button has been pressed.

            Comment

            • robertsmcfarland
              Senior Member of PLANETNAUTIQUE
              • Oct 2004
              • 544

              • Hyco

              • 2014 g23 550

              #7
              nice!!!
              2013 G23 super air
              2010 230 super air
              2009 220 super air
              2008 210 super air
              2005 210 super air
              2003 calabria pro air

              Comment

              Working...
              X