HOW TO remove Seat Back in SSN/SAN 210 ?

[brettmcox]

I need to remove the rear seat back to access the Starter Relay.
I have removed the Seat Sides to update the all the speakers, but can any anyone give some detaills are removing the seat back so that i can access the start relay?

[J10]

it should just lift straight up, there isn't any screws.

[hondaprlud]

On my 04 SAN there were 2 (or 4?) hand screws that needed to be removed from inside the engine compartment side. then it lifts straight up.

[seth]

Are you referring to the 2001 in your signature? My 01 SAN has the bolts attached through the back of the seat and into the fiberglass, there are 3 of them. One each on port/starboard wings and one in the middle portion. Unscrew the nuts and flex the side wings out until the bolts come out and then you can just pull the seat back out.

[brettmcox]

Thanks all. i was think it had to be something like that... i had guessed that someone would have done this before. I hoping that this an 15-30 min to take it and reinstall and about the same for the starter relay.