PC For Windshield and Tower

[Treybizttu]

Like the title says I'm going to powder coat the windshield frame and tower this "winter". Going back with white on the tower and black on the windshield frame. I will get the glass tinted while I'm at it.



Few Questions:
-Removing the tower seems simple enough... Do they sell replacement rubber for the foot pads?
- How in the heck do I remove the "hand screws" that hold the two halves of the tower together?

- On the windshield, do I need any replacement rubber and is that something I can buy pre-made for my windshield?

[wakejunky]

Trey,

To remove the hand screws, there is a little retaining clip that you have to remove and then it'll come out.
The windshield rubber is re-usable unless it's totally sun baked. When you reassemble the windshield the powder coating is thicker than paint so some of the corners where the pieces overlap might be really tight and/or require some spreading of the frame to get the pieces to overlap.

[Treybizttu]

Thanks!


I think I might do the grab rails and cleats in black while I'm at it.