Just want to make sure I am not missing anything for winterizing before we get freezing temperatures. Put stabilizer in fuel tank. I ran 5 gallons of RV Antifreeze through the raw water filter (strainer). Pulled the water strainer and filter out and stored in a zip lock. Pulled the bottom plug on each manifold, let drain, and replaced. Pulled the V-drive plug, let drain, and replaced. Pulled the bottom heat exchanger drain plug and replaced. Took off the drive belt and put in a zip lock to store. Pulled both hoses from raw water (rubber impeller) and took out impeller and stored in a zip lock. Put 1 gallon of RV antifreeze into each ballast vent and ran fill/empty for a moment on each tank. Questions I have are: Can the antifreeze be run through the strainer, while the motor is cold? and is it ok if this was done before the drain plugs were removed. Does the heater get taken care of in of these steps? Anything else I may have skipped, other than taking out batteries, spraying the interior, covering, etc?
Thanks for any replies.
Thanks for any replies.
Comment