Adding RGB wire to tower help.

[Bama 2473]

I added two Rev 10's with RGB light rings and routed the RGB wire to the passenger side front of tower following the existing speaker wire. I'm unable to complete the run because the factory speaker wires are to tight running thru the tower into the boat.

Has anyone pulled the factory wire and added wire as thick as RGB to the harness back thru the tower bolt.

Any help would be great, I don't want to add unneeded hole to the boat.





Sent from my SM-G900V using PLT Nautique mobile app

[Bama 2473]

2008 220

Sent from my SM-G900V using PLT Nautique mobile app

[nautiques4life]

Yep. I'd go with a smaller RGB wire if you're having trouble with that

[210Luke]

Did you ever figure anything out? I’m stuck at the same spot with my Rev10’s install and trying to replace the old wire and run rgb wire as well.


Sent from my iPhone using PLT Nautique

[Bama 2473]

Did you figure this out? If not PM me and I will help.