Roswell Aviator Pro on SV211TE

[08sv211]

Finally complete. Roswell recommended 3-5”” from windshield but that wasn’t going to work on the 211 so we mounted it in the area the step pads were. We ground the lip off and built the area up so the OEM mount would sit flat on gunnel. Then reinforced with an alum plate on bottom side. Then needed to repair the 4 mounting points from old tower.
Added Roswell racks and swivels and a pair of Neptune Speakers with a dual zone control installed in cigarette lighter hole. Made a few calls to Roswell customer service for help during the process customer service was good. Hope to get it in the water tomorrow.

[homer12]

Very nice looking! Are you putting a bimini on it? Also, your old tower went on our boat pretty well! Thanks again for the communication and tips where needed. Front legs lined almost right up. Rear legs need new holes and might need gel patch later down the road.


Sent from my iPhone using PLT Nautique

[NautiqueJeff]

Wow, that turned out great! Nice work!

[NautiqueGermany]

Would love to see more pics! How did you close the old mounting points?
Did you get the Roswell Bimini for it?

[bturner]

That turned out really good. Looks factory!