Wakemakers ExactFit 600lb SAN210 Upgrade - Engine Divider Fix

[tachyon]

I ordered all new support channels, it was just under $100 fo all four shipped. I’m going to go a different route for ballast.

[tachyon]

FYI for everyone dealing with failed divider supports: the new parts that I received from Nautique have reinforcement (est. 1” wide by 1/4” thick) welded to the inside of the channel. This should make a huge improvement over the original parts that were on my 2014 SAN.

I’m really happy to see that Nautique made the design improvement.

See you in Spring!




Sent from my iPhone using Tapatalk

[Vic]

Hi, I know this is an old post...did you end up finding a permanent solution? I was just going to try the plywood, but you are saying it still bent everything ?