There are two nuts on top of my rudder. I assume the top nut is the packing nut and the bottom nut is supposed to be tight up against the packing nut. Boat is a 2011 sport 200. I was greasing the rudder and noticed that the bottom nut was loose. Can someone confirm it should be tight against the packing nut? Picture attached. thank you.
X
-
Tags: None
-
You are correct. The bottom nut is a locking nut to keep the amount of pressure/tension at the correct amount. You do want a slight leak to keep the shaft lubricated. Only a few drops per minute.
-
Wait, this is the rudder shaft, not the drive shaft. The hose you see there is a remote grease point. I don’t think you want the rudder packing to drip water. The grease is there to do the lubrication.
Sent from my iPhone using PLT Nautique
Comment
-
Correct Charlesml3. I may have the names for the two nuts incorrect. I just need to know if the bottom nut should be tight against the top but.
Thanks
Sent from my iPhone using Tapatalk
Comment
-
Comment
Comment