2019 SAN230 well not start

[Hurley]

Here's what happens. Turn battery on. Press start once to accept on screen disclaimers/ warnings. Press start again, Linc screen activates. Awareness cam screen on, radio on. Press start again and will not start. Important note: Noticed on screen that temp shows 32 degrees, 0% gas, 0 hrs.
The problem is intermittent. Clutch is in neutral and emergency safety switch is not activated.

[Johnny_Rock]

I learned my lesson to check fuses...

[Hurley]

Thanks for the reply Johnny_Rock . If a fuse was blown would I still have an intermittent problem or would it only start again once the fuse was replaced?

[charlesml3]

Here's what happens. Turn battery on. Press start once to accept on screen disclaimers/ warnings. Press start again, Linc screen activates. Awareness cam screen on, radio on. Press start again and will not start. Important note: Noticed on screen that temp shows 32 degrees, 0% gas, 0 hrs.
The problem is intermittent. Clutch is in neutral and emergency safety switch is not activated.

Gas gauge and hour meter will show Zero until the ECU is powered up. Sounds to me like it's not getting the signal to start up.

[Infinity]

Did you check to be sure all the wires are connected tightly behind it? Maybe one is loose, causing the intermittent issue. Could also be loose wire or ground at the starter, or the neutral safety switch, etc

[kylant]

op:
seeing you are in Folsom, I bet your boat came from Superior.
Go see them. They are awesome!
I'm sure they will get you back on the water shortly