2015 SAN 210/230 or G Series or newer Driver Seat & Front Seat Electric Seat Heaters

[Ogle12!]

My boat currently does not have the electric seat heaters on the drivers seat or the front seat and I would like to add them. I am trying to gather information in order to install OEM electric seat heaters on the seats of a SAN 230.

Any pictures members can provide on the following would be greatly appreciated:

1. The routing of the wiring for the drivers seat bottom and back heating elements at the seat and as it leaves the drivers seat and "disappears".

2. The routing of the wiring for the front seat bottom and back heating elements at the seat and as it leaves the seat assembly and "disappears". I'm assuming this wiring would be on the back side of the seat, visible when the seat is flipped up.

3. The mounting location of the "On-Off" switch for controlling the front seat electric heat.

[wtrskrs]

I installed seat heaters in my '97 SN but not OEM. So may not be of much help (but I love them!).

[ducatidesmo]

If it was an option, it should be pre wired up to the Molex plug. The only part you have to worry about is adding the heaters to the cushions and routing the wiring in the port side of the seat.

[Ogle12!]

Thank you for your response Ducatidesmo. There is not a harness for either seat electric seat heater in my 2014 SANTE 2014 230, therefore, I need to install everything from the power source up to and including the seat heaters.

This is why I'm looking for pictures showing how the wiring is routed out of and from the drivers seat as well as the front/flip up seat and the location of the control switch for the front/flip up seat.