Tweet
Help wtih Diagnostic Messages?
Hey there everyone,
We have a 2015 G21, with the 550 engine (which we LOVE), and we took it out today. At the end of the day on our way back to the boat ramp, we had a few error messages get thrown. The boat was running great the whole day (even with the error messages). I'm not sure it's related, but we just had our boat serviced at the dealer (fuel filters, impeller, etc), so the timing seems like it could be related. It's been over two years since we've seen any of these diagnostic messages, so the timing seems very coincidental.
I've searched the forums for any mention of these errors, and I cannot find any information on them. Here are the errors that we got:
DTC 8915: UEGO pump cell slow to warm up (SPN: 3225 FMI: 10)
DTC 8901: UEGO microprocessor internal fault (SPN: 3221 FMI: 31)
Third error didn't have a DTC code or description... but showed (SPN: 6000 FMI;10)
I've reached out to our dealer with this same message, but hoping it may be something I could take care of... we have a Lake Powell trip coming up in less than two weeks, so I need to make sure we're all good to go by then.
I would appreciate any guidance or pointers on this... Like I said, the boat was actually running great all day long (even during the diagnostic codes).
Thank you.
Josh P
We have a 2015 G21, with the 550 engine (which we LOVE), and we took it out today. At the end of the day on our way back to the boat ramp, we had a few error messages get thrown. The boat was running great the whole day (even with the error messages). I'm not sure it's related, but we just had our boat serviced at the dealer (fuel filters, impeller, etc), so the timing seems like it could be related. It's been over two years since we've seen any of these diagnostic messages, so the timing seems very coincidental.
I've searched the forums for any mention of these errors, and I cannot find any information on them. Here are the errors that we got:
DTC 8915: UEGO pump cell slow to warm up (SPN: 3225 FMI: 10)
DTC 8901: UEGO microprocessor internal fault (SPN: 3221 FMI: 31)
Third error didn't have a DTC code or description... but showed (SPN: 6000 FMI;10)
I've reached out to our dealer with this same message, but hoping it may be something I could take care of... we have a Lake Powell trip coming up in less than two weeks, so I need to make sure we're all good to go by then.
I would appreciate any guidance or pointers on this... Like I said, the boat was actually running great all day long (even during the diagnostic codes).
Thank you.
Josh P