HELP PCM 343 won't run - SPN 636 FMI 2

[PCMGT40]

We went to ski this morning and I get a fault on Linc.

SPN 636
FM 2
ENG POS Sensor Timing Signal Err

I put a new Crank Position Sensor on it but it made no difference.

Any thoughts?

2011 Nautique 200 with 343

[Jonny Quest]

I believe that you need to have the code cleared. Assuming that the crank position sensor was the culprit, the engine should run after the code reset.

[PCMGT40]

Thanks, it seems to have just been a loose wire in the Crank Position Sensor plug. I just pushed on the the wires and one of them made a little click sound. Put it back together with the original crank sensor and ran prefect the rest of the weekend.

[boatshoplady]

Hello! Wondering if you could let me know where the CPS was located on your engine?