Transom GoPro mounts..rattle??

**charlesml3** · 10-10-2020, 12:24 PM

OK, before you go spending money on this. I don't really think they're all that great. The problem is the camera is always at the very same spot. After about 2 minutes of watching a video from this angle, it gets boring. It's not a bad angle, but good videos use LOTS of different angles. One of the best I've ever seen was an old painters pole. One of those you use to paint walls. With the GoPro on that, the angles get really interesting. You can swing it out wide from the side of the boat. Point it down directly over the surfer, etc.

-Charles

**greggmck** · 10-10-2020, 05:38 PM

Get the GoPro surfboard mounts and find a place on the boat with a better (higher) perspective than the Nautique mount. It does not translate engine vibration into the gopro as much as the Nautique mount and is a far better and cheaper solution.

Sent from my SM-G965U using Tapatalk

**dixxy** · 10-12-2020, 07:48 AM

Originally posted by dixxy View Post

Hi everyone,

Buying a used GS22 without this option and it's something I really wanted...
So in asking the dealer to install this for me they are saying that these things rattle???...WHAT???

I can't see how i could hear this over a 6 litres engine reving at 3000rpm, the water splashing and the music blasting???

Are any of you experiencing this issue??

Thanks for your comments.

Sent from my SM-G960W using Tapatalk

Any other tackers on this one??

Sent from my SM-G960W using Tapatalk

**mcosub** · 10-12-2020, 03:01 PM

I just use the Gopro suction cup mount. I can put it on and take it off quickly and it will stick on any gel coat surface on the back of the boat. I normally put it on the transom or on the outside edge of the rear facing seat on my GS22

Transom GoPro mounts..rattle??

Transom GoPro mounts..rattle??

Comment

Comment

Comment

Comment