Hey All,
I put the boat in the water Saturday and it wouldn't start...starter engages and turns, has a new battery as well. Probably a month before i ran it from my driveway for the 1st time this year...normally, for a 1st start it kicks over almost instantly because of fuel injection, but it took awhile this time (I even had to put a battery charger on it to recharge a bit before starting)...once it did start it ran normal. I put a mulitmeter on batt and it showed that it was charging once started. Then I bought a new battery to replace a 2nd battery that was bad. Kicked it over to make sure it ran (it did and I shut off immediately. So a few days later I put in water on Saturday and tried to start..no go (starter does turn). I removed lanyard and shorted the safety switch wires to bypass the switch, still no start. I don't hear the pump prime when I put it in on position just before start... that's where I'm at now. In a day or so I'm going to put a multimeter on fuel pump to see if it's getting any juice when in on or start position... anything else I should check? I was looking for some sort of fuse box on it but couldn't find one.. any help is much appreciated.. Fred
I put the boat in the water Saturday and it wouldn't start...starter engages and turns, has a new battery as well. Probably a month before i ran it from my driveway for the 1st time this year...normally, for a 1st start it kicks over almost instantly because of fuel injection, but it took awhile this time (I even had to put a battery charger on it to recharge a bit before starting)...once it did start it ran normal. I put a mulitmeter on batt and it showed that it was charging once started. Then I bought a new battery to replace a 2nd battery that was bad. Kicked it over to make sure it ran (it did and I shut off immediately. So a few days later I put in water on Saturday and tried to start..no go (starter does turn). I removed lanyard and shorted the safety switch wires to bypass the switch, still no start. I don't hear the pump prime when I put it in on position just before start... that's where I'm at now. In a day or so I'm going to put a multimeter on fuel pump to see if it's getting any juice when in on or start position... anything else I should check? I was looking for some sort of fuse box on it but couldn't find one.. any help is much appreciated.. Fred
Comment