Tweet
Can someone please tell me or lead me where to find the screw/bolt size I need to screw down the GT40 cover plate. After I brought my 2002 SN in for the 3rd time for a serious engine issue, my mechanic was nice enough to return my boat without these screws, so the cover plate is LOOSE
Also my boat was completely cleaned up by said mechanic after it sunk in my lake in 2018 due to a hurricane. I know he cleaned out the gas tank. I also think he replaced some cushions- total bill was 15K, but insurance totaled it without taking my title so I just had it supposedly fixed. However the clip on the rear bench never stays firmly attached to the anchoring point....is there some trick to getting this seat to stay put. Do I need to adjust where the clip screw in to the wood or do I need several strong people to just squeeze the cushion back under the upper seat back?
Also my boat was completely cleaned up by said mechanic after it sunk in my lake in 2018 due to a hurricane. I know he cleaned out the gas tank. I also think he replaced some cushions- total bill was 15K, but insurance totaled it without taking my title so I just had it supposedly fixed. However the clip on the rear bench never stays firmly attached to the anchoring point....is there some trick to getting this seat to stay put. Do I need to adjust where the clip screw in to the wood or do I need several strong people to just squeeze the cushion back under the upper seat back?
Comment