X
-
You might be right, come to think of it, not sure my Supra would of flipped. The shaft design was not centered, which put the vanes on one side of the case tight, almost flat. Difficult coming out, miserable going in.
Comment
-
-
When you run with perks switch or a water hook up, make sure the seacock for the pick up off the bottom of the boat that normally feeds the strainer is closed, otherwise you could be losing water and pressure out the bottom…. And of course don’t forget to open it after your done!Last edited by jmo; 05-22-2024, 08:33 PM.2018 Ski Nautique 200 TE, H6
- 2006 Ski Nautique 196 LE, Excalibur 330
- 2001 Super Sport Nautique, GT40
Comment
-
-
guys... thanks for you all's responses. I had let my brother install the FakeALake, and he put it on poorly, leaving an air gap in the "plunger" part. This was confirmed because I tested the boat after installing the plunger myself, VERY carefully, and worked just fine from the get go. Either way, freaked me out, and the responses here assured me it was a poor install causing the loss of vacuum. Ended up putting on a new impeller.
Comment
-
Comment