perfect pass python installation ??

[Miljack]

Hi guys,
I'm well into projects and have now tackled the Perfect pass install and I have now discovered some items that I need to get clarification to finish the install;

I need to build my own bracket for the servo motor mount. I have a rough idea, anybody have a pic of one?

Throttle linkage? I've got a note from an owner, but not from anyone I've talked with at PP that I will need to "switch" my throttle control from pull to push to make the perfect pass work, anyone? Apparently this will require that the morse control be swithched from pull to push, but I'll then need to figure out how to get the throttle plates to open by another method. Again pics of an install would be great.

Any other hidden gems on this?

thanks,
Jack

[skijones]

Good luck. The best thing is once you get your throttle problem worked out, the rest is easy. Never worked on a python.

When you run your wiring, leave a extra rope from the bilge to the helm. Running the fish tape is the hardest part.

[WakeSlayer]

I have the PP on mine, you do need a different bracket. I will get a photo of mine for you tonight. I will ask a buddy about the throttle, never heard that before.

[WakeSlayer]

Here are two pics of an install on a 99 SAN. I have no idea about the throttle. Maybe that is a direct drive thing ? Measurements included. I had a weler buddy fashion the plate for me for a case of beer. Easy stuff.

Photo and measurements courtesy of the Zman, another Python Powered Super Air owner.

[Miljack]

Wake slayer,
THANK YOU! This helps a ton. I luv this place... :grin:

[WakeSlayer]

no problem, dude. Always glad to help a fellow Club 502 Member.