2001 SAN stereo cutting out

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • diesel33
    • Jun 2010
    • 27



    2001 SAN stereo cutting out

    Stock cabin speakers and clarion h/u, speakers would pop when the volume would turn up. I replaced the cabins w/ polk db651s and the first time I turned the volume up, they popped. The h/u now is cutting out on me, is it possible I knocked a wire loose? Or is the headunit going on me?

    Thanks
  • super01
    • Jun 2009
    • 277


    • 2008 Super Air 230 2001 Super Air 210 (Sold)

    #2
    I had that stock Clarion in mine. It was just too old tech for me so I replaced it with a Kenwood that you can put your ipod inside.Click image for larger version

Name:	1DSC00088.jpg
Views:	3
Size:	87.8 KB
ID:	361739
    2008 Super Air 230 ZR6
    2001 Super Air 210 GT-40 (Sold)

    Comment

    • Chexi
      1,000 Post Club Member
      • Jan 2025
      • 2119

      • Austin

      • 2000 SAN

      #3
      Could very well be a loose wire. I would start there. But, it could also be the head unit dying. More likely a loose wire though, assuming your clarion unit is the factory marine unit.
      Now
      2000 SAN

      Previously
      1999 Air Nautique
      1996 Tige Pre-2000
      1989 Lowe 24' Pontoon / Johnson 100HP outboard

      Comment

      • EarmarkMarine
        Senior Member of PLANETNAUTIQUE
        • Mar 2008
        • 699

        • Dallas, TX


        #4
        diesel33,
        The fact that you have a popping when you raise the volume would indicate to me a problem other than an intermittent connection.
        You could have low voltage. You could have an issue where the independent grounds for L, Right, F or Rear could be reversed. You could have a source unit that has incurred water damage.
        First, check the voltage.
        Second, wire up a single speaker only with the other three disconnected. Make sure that the speaker positive and ground are part of the same channel. If problem-free then add in one additional speaker at a time. Verify that no load is less than 4-ohms.
        Third, inspect the source unit chassis inside and out looking for a white residue (mineral collection) as an indication of water damage. If you find this then use tuner wash and a Q-tip or very soft toothbrush to remove the residue.
        After that you should know if a new source unit is needed.

        David
        Earmark Marine
        Earmark Marine[URL="http://www.earmarkmarine.com"]
        www.earmarkmarine.com[/URL]

        Comment

        • diesel33
          • Jun 2010
          • 27



          #5
          Thanks David, that information is definately useful.

          Comment

          Working...
          X