G23 Tower Speakers wiring and ohm?

[David Analog]

Read the owners manual carefully. You have to populate at least 50% of the RCA inputs, or 100% depending on how you configure the inputs. The reason you can't get the output voltage up to spec is because you do not have a symmetrical +/- signal when bridged. You're running a positraction differential with a 14" tire on the left and a 22" on the right side. Also, that has to sound like #&@%!

[etang789]

Hopefully you have temporarily disconnected the speakers while setting the gains with this method. Could be a problem getting the output voltage up to spec if you don't have adequate supply voltage to the amplifier (12.5 volt minimum), or without populating all amplifier RCA inputs, or having the input configuration wrong. JL Audio makes a 7 volt line driver, which should not be required to get full output voltage, but could improve the performance.

Need to read post #5 from David. He nails it as usual.

Yea I have double checked my RCA should be feeding to all channels. Please correct me I'm wrong.