New Memphis Amp and Rev10 settings: Help?

[Guntersville230]

Working on settings for a new amp install....long story short boat is a good ways away from any marine audio place and want to do some initial amp tuning myself. This is the amp and the specs: 4 channel bridged into one pair of rev10’s

MLA you always have solid advice any help would be much appreciated!!!



16-MXA4.480 - Memphis 4-Channel 480W RMS 960W Max Full Range Class D Amplifier

RMS Power 4-Ohm: 80 x 4 RMS Power 2-Ohm: 120 x 4 RMS Power: Bridged Mono Power 4-Ohm: 240 x 2

[MLA]

Your retailer(s) should always be first inline to assist with the products you purchased. I would get with your memphis dealer/installer as they should know exactly how to properly bridge and configure the memphis amps. If they do any marine installs, they should have a good idea on the appropriate settings for a 10" HLCD. If your memphis dealer is not also your wet sounds dealer, defenitely contact that dealer and have them lay out some reasonable amp tuning settings for those speakers, based on the amp's specs.

[chrisschweda]

hook up to the bridged channels then set the frequency to 100-125 hz on the settings turn radio 3/4 the way up tune gain till it does not clip/ distort and you are good