Amp and Sub location??

[jayman1]

noise

I agree with Holywood about the signal wires being ran together. You might get a little unwanted noise but I always heard that you could not run RCA and power wires together. I guess they are the same thing - RCA and speaker - they are both carrying the signal???

Nice install though and good idea with the amps covered in plastic.

[wakejunky]

I did what I had to do to get the wires where they needed to be. I haven't noticed any interference in signal.

Chris

[Hollywood]

possible interference

If everything sounds good, that's great. I was just throwing that out there incase you did come across a problem. RCA wires carry the signal from the receiver to the amp. Then your speaker wires carry the 'amplified' signal from the amp to the speakers. So intern, they both carry the signal. Either wire can pick up interference. A RCA wire getting inteference will be especially bad because that will also get amplified.

Moral of the story, "If it ain't broke, don't fix it"

[imported_pjdave]

heres some of our install ideas

[imported_pjdave]

more

[imported_pjdave]

and the tower box i am building for the 04 san, using 2 eminence compression drivers